Technics SA-DX940 User Manual

Speaker Connections
Center speaker
Front speaker (not included) Front speaker
(ielt) (right)
(not included) (not included)
/"" "'. : ." Subwoofer
." " 30° _3C_/ (not included)
,' ". i .,"
/ ""_-""
' ! .... ..... i
•-" Surround speaker
' Surround speaker ",,,, .--
(_elt) ......... (right)
i (not included) ..................... (not included)
Front speakers
Place on the Heftand right of the TV at seated ear height so that
there is good coherency between the picture and sound.
Center speaker
Place underneath or above the center of the TV. Aim the speaker
at the seatingarea+
Surround speakers
Place on the side of or slightly behind the listening position, about
one meter higherthan ear level.
Subwoofer
The subwoofer can be placed in any position as long as it is "at a
reasonable distance from the TV.
Note that some experimentation can yield the smoothest low
frequency perlofmanoe. Placement near a comer can increase the
apparent output level, but can result in unnatural bass.
Other connections are possible depending on your speaker system.
See your speaker system's operating instructions for details.
I Front speakers ]
I_FJ
Speaker impedance:
AorB: 4-8_
Aand B: B P+
If you connect speakers with an impedance
under 8 _. switch on "LOW IMP" (,_ page 25).
Front speaker
(right)
_not included)
/
Speaker cable
(not incruded)
SPEAKERS
r_
FRONT
Front speaker
(left)
(not included)
Speaker cable
(not included)
"B"terminals
For connection to a second pair of
--speakers,
Use the A terminals to enjoy
Dolby Digital, Dolby Pro Logic,
DTS and SFC.
ROT5308
f
Connecting the cables
(Front "A" terminals)
1 2 g
NO
(Other epeaker terminals)
NO

Technics SA-DX940 Specifications

General

Impedance	8 ohms
Input Sensitivity	200mV (line)
Power Output	100 watts per channel into 8Ω (stereo)
Inputs	CD, Tape, Phono
Tuning Range	FM
Surround Output	100 watts (front), 100 watts (center), 100 watts (rear)
Video Connections	composite
Dimensions	430 x 158 mm
Speaker Load Impedance	8 ohms