t
• £' ; £• • . •
The procedures below are examples for when a TV and VCR are connected to the receiver as shown in this manual.
This remote control is designed for use with a home theater system. If you press [TV] (or [VCR]) and [ _) ] in succession, the TV (or VCR)
and receiver will be turned on and he se ector on the receiver will change to TV (or VCR) Press [ _ ] within 3 seconds of
• pressing [TV] (or
[VCR]).
To watch TV broadcasts
Point the remote Point the remote Point the remote control
control toward the control toward toward the TV
TV and the receiver the TV
. 0 ..0,0 ©©©
o -* o., o., 6°"© 0r©©©
s.,,cb SettheTVN,DEO ©©©©
and the receiver, mode on the TV
to "TV". Select the desired channel.
The receiver will
switch to TV input.
If you allow more than 3 seconds to pass between pressing [TV] and [ _ ], only the TV will be
operated.
DO not use this remote control to turn the TV ON and OFF if you are not using the receiver.
To watch TV broadcasts with a VCR tuner
Point the remote Point the remote control
control toward the TV toward the VCR and
and the receiver the receiver Set the input
TV € VCR 5 selector on
0 I_ 0 I_ 0 I_ 0 I_ the VCRto
the "TUNER"
Switch ON the TV Switch ON the VCR. position
and the receiver.
The receiver will switch
to VCR input
ii
Point the remote control toward the VCR
i 2 3 Point the remote control
(_CH(_) 000 toward the TV
or©©© 4"
©6©© SettheTV,,,OEO
mode on the TV
Select the desired channel, to "VIDEO"•
If you allow more than 3 seconds to pass between pressing [VCR] and [ _ ], only the VCR will be
operated.
Do not use this remote control to turn the VCR ON and OFF if you are not using the receiver.
To switch OFF the TV
TV
O,,_O
To switch OFF the VCR
VCR
Turn the receiver OFF last.
This button is used when using ENTER to select a channel on a TV or VCR
which has not been manufactured by this company.
#:
ROT5308
To Next Page
Loading...
