3
1
2
3
12
I
POWER
_b/I
A SPEAKERSB
ASPEAKERSB
i- T 7C
_r _
Preparatory steps
These settings should be done to get the most from the unit's
reproduction modes (-k pages 20-21).
Front, center, and surround channel settings
Set the SIZE, DISTANCE, and FILTER for your speakers.
In SIZE
Set the type (LARGE or SMALL) and presence of your speakers.
Select "LARGE" if the speakers can produce bess (below around
100 Hz). Select "SMALL" if the speakers cannot produce bass. If
you aren't using center or surround speakers select "NONE" so
the sound is produced through the front speakers.
The speaker channels are all set to "LARGE" before shipping. If all
your speakers are LARGE, you may skip this operation.
In DISTANCE
Enter the distance of each speaker irom the listening position so
the sound from the speakers reaches the listening position at the
same time. The unit calculates the delay time _or the center and
surround speakers based on these distances.
In FILTER
Enter the cutoff frequency for your subwooler based on the bass
capability of your front speakers
The factory setting is 100 Hz.
1 Press [POWER, (_/I].
2
3
Press [A] and [B] at the same time.
"SETRNG" appears on the display.
Press [A] to select what you want to
set.
Each time the button is pressed the display switches as
follows.
SIZE _ DISTANCE _ FILTER _ DR COMP
I
(continued on next page)
RQT5308
To Next Page
Loading...
Need help?
General
