4 4
5
4
"SIZE"
(_ ASPEAKERSB
(_ SFOMODE
• i'l-_l II tl i
I. I II: ,II _I:
"DISTANCE"
(_ ASPEAKERSB : :
• i I_[ _1i:II i_:
(_ SFCMODE
....
"FILTER"
SFCMODE
• : I i _ I
ASPEAKERSB
"1 I. IL Ilmll I- I I
4
Preparatory steps
When "SIZE" is selected
(_) Press [B] to select the speaker
channel to be set.
Each time the button is pressed the display switches as
follows.
FRONT ---*-CENTER _ SURROUND
I
(_) Turn [SFC MODE] to set the type
(LARGE, SMALL) and presence
(NONE) of the speaker.
Each time the selector is turned the display switches as
follows.
Front:
SMALL _ LARGE
Center, Surround:
NONE _SMALL _ LARGE
Select "NONE" if a center and surround speaker isn't
connected.
® Repeat steps _ and _ to
complete at the size settings for
the front, center and surround
speakers.
When "DISTANCE" is selected
(D Press [B] to select the speaker
channel to be set.
Each time the button is pressed the display switches as
follows.
FRONT _CENTER _ SURROUND
!
(_ Turn [SFC MODE] to set the
distance.
Distance can be set at I foot intervals between 3 feet
to 30 feet.
The factory settings are as follows.
Front and center speakers: 10 FEET
Surround speakers: 5 FEET
® Repeat steps @ and @ to complete
the distance settings for the front,
center and surround speakers.
When "FILTER" is selected
Turn [SFC MODE] to set the cut off
frequency,
Each time the selector is turned the display switches as
follows.
100 _150_ 200
5 Press [A] and [B] at the same time.
"COMPLETE" appears on the display.
If you allow about 10 seconds to elapse between settings, the
procedure is cancelled, all settings are returned to how they were,
and the previous display is restored. Begin again if this occurs.
For your reference:
The settings remain as they are until changed by the above
procedure, even after the power has been turned off.
RQT5308
To Next Page
Loading...
