• _, _ , _i _,
DELAY I
LEVEL J: ° _' -
8
Enioying the sounds
7 Start the source.
8 Adjust the volume.
I While using the SFC modes I
To adjust speaker level ....
O Press [LEVEL] to select the speaker channel to adjust.
Each time the button is subsequently pressed, the speaker
whose level is to be set is seleoted in the listed sequence•
C _ RS _ LS---_SW
Speakers for which "NONE" or "OFF" has been set are
skipped.
Press [-] or [÷] to adiust the output revel.
Channels C, RS, LS, and SW can be adjusted between 10 dB
and +10 dB, "
To adjust delay time "' - ....
You can adjust surround channel only,
0 Press [DELAY].
When the button is pressed, the current delay time is
displayed,
(_ Press [-] or [+] to set the time.
Select a delay time to suit your individual needs.
Delay time can be set at 10 milliseconds (ms) intervals
between 10 and t00 ms.
The factory settings for each mode are 50 ms.
For your reference
Settings for volume level and delay time can be done for each
SFC mode.
f_
8
VOLUME _)
When you finish listening
Re sure to reduce the volume, and switch the power to the
standby condition by pressing [POWER, Q/I].
(_ For your reference
• If you are using VCR and you select TAPE, CD, TUNER, or
x
PHONO
The picture will remain on the screen.
• About DSP mode
The DSP modes can be set for each source. Once you have set
the mode for a source, the mode is engaged whenever that
source is selected.
These modes are automatically switched to STEREO if
SPEAKERS B is selected or both speakers are turned off. When
SPEAKERS B is turned off or SPEAKERS A is selected, the
mode is switched back to the latest mode,
• Only Dolby Digital, DTS or PCM signals (44.1 kHz or 48 kHz)
can be reproduced through the digitat terminal
The digital input signal of sampling frequencies 96 kHz and
other signal formats such as MPEG cannot be reproduced on
this unit.
RQT5308
To Next Page
Loading...
