AccuLoad IV Installation & Maintenance Manual
Closing and Sealing the Enclosure 60
5.2.1 Sealing ST and QT Models
On the ST and QT models, the sealing wire is threaded through holes in two cover bolts, as shown in the
following drawings.
5.2.2 Sealing N4 Models
To seal NEMA 4 enclosures, thread the sealing wire through any of the cover-locking clamps opposite the
hinge.
Figure 53: AccuLoad Model ST Sealing
Seal Wire
Cross
drilled
bolts
Standard
bolts
Figure 54: AccuLoad Model QT Sealing
Standard Bolts
Cross drilled bolts
Seal wire
To Next Page
Loading...
