3.3 Connection
> The audio outputs audio out analogue (18), optical out digital (20) or coaxial out digital (21) are available on the back
of the device to connect an A/V amplifier or a stereo system.
> Connect the supplied aerial antenna to the antenna connection (23).
> Depending on whether you wish to use the LAN connection or the WLAN connection, connect the LAN cable for your
network to the LAN connection (22), or raise the WLAN antenna (17).
> Then insert the mains cable into a 110-240V ~ 50/60Hz mains outlet.
3.4 Switching on/o
> To switch on the DIGITRADIO 143 CD, press the on/standby buon on the device (15) or on the remote control (14).
> To switch o, press the on/standby buon on the device (15) or on the remote control (14) again.
3.5 Source selection
> Press the MODE buon on the device (5) or on the remote control (8) repeatedly to scroll through the available sources.
Alternatively:
> Open the submenu in the current source by pressing the MENU buon and select >Main menu.
The source currently selected is shown on the display.
3.6 Adjusting the volume
> Rotate the volume knob (15) on the device to the right or press the VOL+ (23) buon on the remote control to increase
the volume. Rotate the volume knob (15) on the device to the le or press the VOL- (10) buon on the remote control
to reduce the volume.
The set volume is shown on the display while it is being adjusted.
18