EasyManuals Logo

TechniSat DIGITRADIO 143 CD User Manual

TechniSat DIGITRADIO 143 CD
380 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
4 Initial set-up
Aer switching on the DIGITRADIO 143 CD for the first time, the initial set-up wizard starts.
Seings can all be changed at any time in the future.
> To launch the initial set-up wizard, use the arrow buons on the remote control to select the [YES] field and press the
OK buon.
> In the next step you can select the time format. Select the desired seing [12] or [24] and press the OK buon to move
on to the next step.
> Here it is possible to select which source (DAB+, FM or the Internet) the DIGITRADIO uses to obtain and update the time
and date. Once selected, proceed to the next step to enter the time zone to ensure that the time is displayed correctly.
> Proceed to specify whether summertime or wintertime is applicable at the time of seing.
> In the next step you can specify whether the DIGITRADIO should remain connected to the Internet when on standby.
Power consumption is, however, increased by using the standby mode.
> The network wizard then starts and you can set up an Internet connection. Use the OK buon to select your familiar
WLAN network and enter the password using the displayed keyboard. Then select and press the OK buon. If
the password entered is correct a connection to the network is now established. The signal bar
in the status bar of
the display indicates whether the connection has been established. To cancel the entry, select and press the OK
buon. If you make a typing error you can delete the last leer entered using
.
When the virtual keyboard is shown on the display, you can browse using the arrows buons and the VOL+/- buons
on the remote control. The up/down arrow buons move the highlight upwards and downwards, the VOL+/- buons
move the highlight to the right and le.
> If you have connected the DIGITRADIO to the network using a LAN cable, select the [CABLE] item.
> Aer completing the network set-up, confirm the message that the initial set-up has been completed by pressing the OK
buon.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TechniSat DIGITRADIO 143 CD and is the answer not in the manual?

TechniSat DIGITRADIO 143 CD Specifications

General IconGeneral
Package weight3600 g
Package depth130 mm
Package width500 mm
Package height340 mm
Disc types supportedCD, CD-R, CD-RW
Optical drive includedYes
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)1.7 W
Power consumption (typical)15 W
Audio formats supportedMP3
HDMI in-
Audio (L/R) in1
Headphone connectivity3.5 mm
Receiver typestereo
Audio output channels- channels
Power output per channel (20-20KHz@8 Ohm)- W
DisplayTFT
Apple dockingNo
Product colorBlack
Display resolution240 x 320 pixels
Bluetooth version4.2
Bluetooth profilesA2DP, AVRCP
FM band range87.5 - 108 MHz
Supported radio bandsDAB+, FM, UKW
Internet radio services supportedSpotify
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)5 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth290 mm
Width435 mm
Height75 mm
Weight2750 g

Related product manuals