46
14.2.3 Display seings
> Select [Display seings] to display the current network seings.
14.2.4 Manual seing
Manual seing of the connection parameters is described for LAN in Section 14.2.1.2 and for a wireless network (WLAN) in
Section 14.2.2.3.
14.2.5 NetRemote PIN setup
Under certain circumstances, it may be necessary to secure the connection to the DIGITRADIO 143 CD with a PIN.
> Enter a 4-digit PIN under [NetRemote PIN Setup].
14.2.6 Delete network profile
Use this menu item to end an existing connection to a WLAN and to delete the seings carried out. If you want to connect the
device to this network again, all the seings need to be carried out again.
14.2.7 WLAN/LAN connection on standby
> Under [Allow WLAN/LAN on standby?], select whether the WLAN/LAN connection is to be maintained in standby mode
(YES) or not (NO).
14.3 Time seings
> Via MENU > System seings > Time and date you can retrieve and configure the seings for the time and date.
14.3.1 Time/date seing
> Select [Time/date seing] to set the time and date manually.
> Use the p or q arrow buons to change a value and confirm by pressing the OK buon.
Each time the OK buon is pressed, the highlight skips to the next value.