EasyManuals Logo

TechniSat DIGITRADIO 143 CD User Manual

TechniSat DIGITRADIO 143 CD
380 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
1 Important information
Please take note of the following information to minimise safety risks, to prevent damage to the device and to make a
contribution to environmental protection. Please read all the safety information carefully and keep it for future reference. Always
observe all warnings and information in this quick start guide and on the rear of the device.
Caution - This identifies important information that must be observed to prevent device defects, data loss/misuse or
undesired operation.
Tip - This identifies information relating to the described function, as well as to another related function that may have to
be taken into account, with reference to the corresponding section in the manual.
1.1 Safety
For your own protection you should read the safety notes carefully before using your DIGITRADIO 143 CD. The
manufacturer accepts no liability for damage caused by improper handling and by not observing the following safety
precautions:
- Never open the device! Touching live parts can be fatal!
- Any required intervention may only be performed by qualified sta.
- The device must only be operated in an appropriate climate.
- In the event of extended transport in the cold and a subsequent change to warm rooms, do not switch on immediately;
wait for the temperature to equalise.
- Do not expose the device to dripping or splashing water. If water has penetrated the device, switch it o and inform the
Service department
- Do not expose the device to heat sources which could heat it up more than normal use will.
- In a thunderstorm, disconnect the device from the mains. Overvoltage can damage the device.
- If you detect a device defect, odour or smoke, a major malfunction, or damage to the housing, switch o the device and
inform the Service department.
- The device must only be connected to a mains voltage of 100V-240V~, 50/60 Hz. Never try to operate the device at any
another voltage.
- The device must not be connected until the installation has been completed according to regulations.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TechniSat DIGITRADIO 143 CD and is the answer not in the manual?

TechniSat DIGITRADIO 143 CD Specifications

General IconGeneral
Package weight3600 g
Package depth130 mm
Package width500 mm
Package height340 mm
Disc types supportedCD, CD-R, CD-RW
Optical drive includedYes
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)1.7 W
Power consumption (typical)15 W
Audio formats supportedMP3
HDMI in-
Audio (L/R) in1
Headphone connectivity3.5 mm
Receiver typestereo
Audio output channels- channels
Power output per channel (20-20KHz@8 Ohm)- W
DisplayTFT
Apple dockingNo
Product colorBlack
Display resolution240 x 320 pixels
Bluetooth version4.2
Bluetooth profilesA2DP, AVRCP
FM band range87.5 - 108 MHz
Supported radio bandsDAB+, FM, UKW
Internet radio services supportedSpotify
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)5 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth290 mm
Width435 mm
Height75 mm
Weight2750 g

Related product manuals