TechniSat DigitRadio 360 CD

31
EN
FR
IT
NL
NW
DK
PL
CZ
SK
6.2 DAB radio reception
> To switch on DAB mode, press the MODE (2) buon on the device as oen as required until DAB Radio
is shown in the display, or use the TUNER/DAB (30) buon on the remote control.
If the device is being started for the first time, a complete scan is performed and a station list added. In
order to perform a complete scan, open the menu by holding down the Info/Menu button and use the
Tune +/ - and Enter buttons to select the menu item [Complete Scan].
6.3 Performing the automatic scan
The automatic scan (Full Scan) scans all DAB Band III stations and thereby finds all stations being
broadcast within the reception range.
In order to perform a complete scan, open the menu by holding down the Info/Menu button and use
the Tune +/ - and Enter buttons to select the menu item [Complete Scan].
> In order to perform a full scan, use the MENU (34) buon in DAB mode to open the menu and select
the Full Scan menu item using the ENTER (27) buon on the remote control, or by pressing the SELECT/
VOLUME (5) knob.
Alternatively:
> You can also press the SCAN (37) buon on the remote control.
Scan appears on the display.
During the scan a progress bar is displayed.
If no stations are found, check the antenna and change the installation location if required (section
4.3.2).
31