Chapter 6 Remote Access via Web Client
Use the Web Client to remotely access your WIRELESS NVR at any time via a PC. Before you
access the Web Client, you need to ensure that the network settings of the WIRELESS NVR are
configured properly. The most convenient and easiest way is if you have set the WIRELESS NVR
a static IP address (please see “5.5.1 Network”). It means you only need to open the web browser
on your PC and type in the static IP address you have set on the WIRELESS NVR. However, if the
IP address of the WIRELESS NVR is assigned by a DHCP server (see“5.5.1 Network”), then it
means that each time you reboot the WIRELESS NVR, the IP address changes. In this case, ask if
your ISP can provide you a static IP address. If not, then configure the DDNS service. See the
network settings in “5.5.4 DDNS”.
System Environment Requirements
The minimum requirements for hardware and OS required to run Web Client are given as below.
Microsoft Internet Explorer (Ver. 11,10,9,8)
To Next Page
Loading...