TP8-96 VIDEO - Installer Manual Programming of telephone section
3-5
GPRS
z Enabling
Permits enabling/disabling of the GRPS channel functioning of the integrated GSM module.
z Port
Access to the Tecnoalarm Tecnoserver. The default value is 10001.
z Access point
Defines the access point to the network. The GPRS connection is not like a telephone line, but similar to the
Ehernet connection. The connection is made via Internet network. Therefore, it is necessary to enter the network
through an Access point. The access parameters are provided by the telephone service provider.
z Username
z Password
SMS
z COMMANDS-SMS enabling
Permits enabling/disabling of the remote control management by SMS.
z Password
Password (max. 8 alphanumerical digits) to be included in the SMS.
z White list
List of the telephone numbers enabled for the SMS commands.
If the white list contains telephone numbers, the control panel accepts the SMS commands only from the
programmed numbers. If no number has been programmed in the white list, the control panel accepts the SMS
commands from any telephone number.
See § 3.2 for explanatory notes.
Press:
z OK to confirm and quit
z Abandon to quit without saving
WARNING
Since the international prefix is not considered by the control of the number, it is not necessary to
enter it.
WARNING
Since the access parameters to the GPRS may vary according to the telephone service provider, it is
recommended to contact the service provider for more detailed information.
To Next Page
