Tecnoalarm TP8-96 - Introduction to the TP8-96 Video System; Programming Menu

TP8-96 VIDEO - Installer manual
Introduction to the TP8-96 VIDEO system
1-1
1.1 PROGRAMMING MENU
Description of the programming menus.
z Advanced: Enabling or disabling of advanced programming level.
N.B. It is possible to enable the advanced programming level only if you are in
possession of the corresponding license.
z Automatic wiring: Enabling or disabling of the automatic wiring function.
N.B. All the other items of the option window are disabled.
z Zones: Association of the logical zones to the physical zones, alphanumerical
description, enabling of voice message, zone type, alarm cycles, alarm counter,
contact type, configuration of the connected detector, enter filter and sensitivity
z Zones-functions: Association of the following functions to the zones: siren, PGM, by-
pass, coinciding zone, chime, non excludable zone, common zone
z Zones-programs: Association of the zones to the programs, alphanumerical
description of the programs, enabling of the voice message
z Consoles: Console configuration, association of the program status LED to the
programs, quick arming/disarming, panic alarm, quick menu, chime, audio settings,
message scheduling
z Keypoints: Association of the programs
z Options: Buzzer section, wireless section, voice report, key zone properties, single
arming mode, enabling/disabling tamper, antimasking control, association of the
siren and PGM outputs to the programs
z Outputs: Output configuration, polarity programming
z Bus sirens: Association of the sirens to the programs, after sound blinking, volume
setting, siren mode, sound type, functioning mode, enabling/disabling of the antifoam
and antidrilling protection
PROGRAMMING OPTIONS
ZONE CONFIGURATION
1. INTRODUCTION
PROGRAMMING OPTIONS