TECO E510s Series - Page 207

4-141
Group 06 Automatic Program Operation
06- 00 Auto Run Mode Select
Range
【0】：Disable
【1】：Execute a single cycle operation. Restart speed is based on the previous
stopped speed.
【2】：Execute continuous cycle operation. Restart speed is based on the
previous cycle stop speed.
【3】：After completion of a single cycle, the on-going operation speed is
based on the speed of the last stage. Restart speed is based on the
previous stopped speed.
【4】：Execute a single cycle operation. Restart speed is based on the
Speed-Stage 0.
【5】：Execute continuous cycle operation. Restart speed is based on the
Speed-Stage 0.
【6】：After completion of a single cycle, the on-going operation speed is
based on the speed of the last stage. Restart speed is based on the
Speed-Stage 0
Range 【0.00~599.00】Hz
Frequency setting of speed-stage 0 is based on parameter 05-01
06- 01 Frequency setting of speed-stage 1
06- 02
Frequency setting of speed-stage 2
06- 03
Frequency setting of speed-stage 3
06- 04
Frequency setting of speed-stage 4
06- 05
Frequency setting of speed-stage 5
06- 06
Frequency setting of speed-stage 6
06- 07
Frequency setting of speed-stage 7
06- 08
Frequency setting of speed-stage 8
06- 09
Frequency setting of speed-stage 9
06- 10
Frequency setting of speed-stage 10
06- 11
Frequency setting of speed-stage 11
06- 12
Frequency setting of speed-stage 12
06- 13
Frequency setting of speed-stage 13
06- 14
Frequency setting of speed-stage 14
06- 15
Frequency setting of speed-stage 15