TECO E510s Series - Page 208

4-142
Range 【0.0~6000.0】Sec
06- 16 Operation time setting of speed-stage 0
06- 17 Operation time setting of speed-stage 1
06- 18 Operation time setting of speed-stage 2
06- 19 Operation time setting of speed-stage 3
06- 20 Operation time setting of speed-stage 4
06- 21 Operation time setting of speed-stage 5
06- 22 Operation time setting of speed-stage 6
06- 23 Operation time setting of speed-stage 7
06- 24 Operation time setting of speed-stage 8
06- 25 Operation time setting of speed-stage 9
06- 26 Operation time setting of speed-stage 10
06- 27 Operation time setting of speed-stage 11
06- 28 Operation time setting of speed-stage 12
06- 29 Operation time setting of speed-stage 13
06- 30 Operation time setting of speed-stage 14
06- 31 Operation time setting of speed-stage 15
Range
【0】：Stop
【1】：Forward
【2】：Reverse
06- 32 Operation direction selection of speed-stage 0
06- 33 Operation direction selection of speed-stage 1
06- 34 Operation direction selection of speed-stage 2
06- 35 Operation direction selection of speed-stage 3
06- 36 Operation direction selection of speed-stage 4
06- 37 Operation direction selection of speed-stage 5
06- 38 Operation direction selection of speed-stage 6
06- 39 Operation direction selection of speed-stage 7
06- 40 Operation direction selection of speed-stage 8
06- 41 Operation direction selection of speed-stage 9
06- 42 Operation direction selection of speed-stage 10
06- 43 Operation direction selection of speed-stage 11
06- 44 Operation direction selection of speed-stage 12
06- 45 Operation direction selection of speed-stage 13
06- 46 Operation direction selection of speed-stage 14
06- 47 Operation direction selection of speed-stage 15
 Auto run mode uses frequency reference parameters (05-01, 06-01~06-15), operation time
parameters (06-16~06-31) and direction of operation parameter (06-32~06-47)
 Auto run mode can not be used when “Wobble Frequency function” or “PID function” is
enabled.
 In auto run mode, multi-speed frequency reference of external signal 1~4 (03-00~03-07=2~5)
is disabled.