4-144
(3) Auto Run Mode for Single Cycle (06-00=3,6)
The speed of final step will be held to run. (The final step must be put in stage 15)
All other parameters are set same as “Example 1” shown above.
Freq.
50 Hz
30 Hz
15 Hz
20 Hz
20s 25s 30s 40s
05-01
06-01
06-02
06-15
06-16 06-17 06-18
06-31
Figur 4.3.54 Auto Run Mode for Single Cycle
When 06-00=1~3：After a restart, it continues to run from the unfinished step.
When 06-00=4~6：After a restart, it will begin a new cycle.
06-00 1~3 4~6
Output Frequency
time
Output
Frequency
Run
Command
Continue running from
unfinished step
stop runrun
time
Output
Frequency
Run
Command
begin a new cycle
stop runrun
ACC/DEC time in Auto run mode will be according to the setting of 00-14/00-15.
For Auto sequence 0.The run frequency will be according to keypad frequency set by parameter
05-01.Parameters 06-16 and 06-31 are used to set the sequence Run time and Run direction.
To Next Page
Loading...
