4-193
Group 12 Monitoring Parameters
12- 00 Display Screen Selection (LED)
Range
(Highest bit) 0 0 0 0 0 (Lowest bit)
The value range if each bit is 0~8 from the highest bit to the lowest bit
【0】：No display
【1】：Output current
【2】：No display
【3】：DC busvoltage
【4】：heatsink temperature
【5】：PID feedback
【6】：AI1 value
【7】：AI2 value
【8】：Counter
Notes：
The highest bit is used for power-up monitor. The 4 least significant bits can be used to customize
the display sequence see page 4-4.
12- 01 PID Feedback Display Mode (LED)
Range
【0】：Display the feedback value in integer (xxx)
【1】：Display the feedback value with one place after the decimal point (xx.x)
【2】：Display the feedback value (x.xx) with two places after the decimal point
12- 02 PID Feedback Display Unit Setting (LED)
Range
【0】：xxxxx (no unit)
【1】：xxxPb (pressure)
【2】：xxxFL (flow)
12- 03 Line Speed Display (LED)
Range
【0~60000】RPM
12- 04 Line Speed Display Mode (LED)
Range
【0】：Display Inverter Output Frequency
【1】：Line Speed Display at Integer. (xxxxx)
【2】：Line Speed Display at One Decimal Place. (xxxx.x)
【3】：Line Speed Display at Two Decimal Places. (xxx.xx)
【4】：Line Speed Display at Three Decimal Places. (xx.xxx)
When 12-04=0, Inverter displays the line speed at stop, operation or the modification of
frequency.
When 12-04≠0, 12-03 is set to the maximum line speed and corresponds to the maximum
output frequency.
For example：
If the line speed display of 12-03 is 1800, the keypad display is 900 when frequency output is 30Hz.
To Next Page
Loading...
