4- 252
4. Operation control function
Symbol Description
Forward /Reversal control can be set by ( I1~f8 )
OFF：Forward(FWD)
ON：Reversal(REV)
Speed terminal control can be set by ( I1~f8 )
OFF：Operation based on set frequency
ON：Operation based on frequency of speed
Set frequency (can be constant or V3、V4，V5 )
Speed frequency (can be constant or V3、V4，V5)
Acceleration time (ACC Time)
Deceleration time (DEC Time)
Operation command output
(F1 to F8, there are a total of 8 operation control functions)
Example：
F1
F1
I1
Q1
RUN/STOP of F1 is determined by
ON/OFF of I1
10.00
10.00
60.0
30.0
F1
M1
M2
F1 is ON inverter starts running
and at the same time, the F1 input of the
ladder program is ON as well.
Input from Function Program
Input from the Ladder Program
n
n
To Next Page
Loading...
