Press/ hit the emergency stop switch on the HMI
panel to bring the machine to a complete halt.
Note:
The machine cannot be restarted until the
emergency stop switch is depressed by twisting it in
the clockwise direction.
Turn the speed knob to adjust the drill press motor
set speed at all times.
Turn the speed knob in the clockwise direction to
increase the set speed
Turn the speed knob in the anti-clockwise direction
to decrease the set speed. For fine speed
adjustment, push the knob in then turn.
The drill press set speed can be adjusted at any
time while the drill press is turned on. When the set
speed knob is turned, the HMI screen will
automatically display the current set speed on the
drill press.
To Next Page
Loading...
