Teknatool Nova 83700 - Speed and Behaviour Settings

24
123-0420-029
Calibrating the Height Sensor Drill Press
Press and hold the <Zero/ Confirm> button and press the <OFF> button.
Note:
Do not release the <Zero> button.
Hold the <Zero/ Confirm> button for another 1~2 seconds.
1.
2.
3.
The HMI screen will display a “C” and then a certain depth on the screen.
Extend the drill press quill to the depth that is being displayed on the screen.
Press <Set Depth> button to calibrate at the specified depth.
Unlocking the drill press speed range to 5,000rpm
The NOVA Viking drill press can achieve a maximum operation speed of up to 5,000rpm (default setting at
3000rpm). This speed is ideal for metal working purposes where it requires very fast rotation speeds
Press and hold the <Display/ Cancel> button and press the <OFF> button.
Note:
Do not release the <Display/ Cancel> button.
Hold the < Display/ Cancel> button for another 1~2 seconds.
1.
2.
3.
Press
and
hold
Keep hold
Press briefly
Keep holding
for another
1~2 seconds
Press
and hold
Keep pressing
Press briefly
Keep holding
for another
1~2 seconds