1. SEEK INSTRUCTION. If you are not thoroughly familiar
with the operation of drill press, obtain advice from your
supervisor, instructor, or other qualified person.
Instruction from a qualified person is strongly
recommended.
2. DO NOT OPERATE DRILL PRESS until it is completely
assembled and installed. Follow instructions and
recommendations.
3. FOLLOW ELECTRICAL CODES. Make sure wiring codes
and recommended electrical connections are followed
and that the machine is properly grounded.
4. WHEN REPLACING THE FUSE (on relevant models),
completely isolate power when removing the fuse. It is
imperative the plug is removed from the power supply
before the fuse is removed. Replace fuse cap before
reconnecting to power.
5. DO NOT OPEN THE SWITCH AND REAR COVERS.
Components can carry dangerous voltages even when
isolated from mains power.
6. KEEP WORK AREA CLEAN. Do not turn the drill press
on before clearing the drill press of all objects (tools,
scraps of wood, etc.). Keep the nearby area and floor clear
of debris.
7. CHECK SET-UP with spindle off. Examine the set-up
carefully and rotate the work piece by hand to check
clearance and check speed is correctly selected before
turning on spindle.
8. DO NOT MAKE ADJUSTMENTS when the drill press
spindle is turning. Make all adjustments with power OFF.
9. TIGHTEN ALL CLAMP HANDLES on the drill press before
operating drill press.
10. ALWAYS CHECK CORRECT SPEED IS SELECTED
BEFORE SWITCHING ON DRILL PRESS.
11. OPERATE AT RECOMMENDED SPEED. Always operate
the drill press at the recommended speeds. Consult the
built-in speed chart on the drill press for suggested
speeds.
12. DO NOT OPERATE DRILL PRESS IF DAMAGED OR
FAULTY. If any part of your drill press is missing, damaged
or broken, in any way, or any electrical component fails, shut
off the drill press and disconnect the drill press from the
power supply. Replace missing, damaged, or failed parts
before resuming operation.
13. ADDITIONAL SAFETY INFORMATION (only for
applicable regions) regarding the safe and proper
operation of this product is available from the National Safety
Council, 444 N. Michigan Avenue, Chicago, IL 60611 in the
Accident Prevention Manual of Industrial Operations and also
in the Safety Data Sheets provided by the NSC. Also refer to
the American National Standards Institute ANSI 01.1 Safety
Requirements for Woodworking Machines and the U.S
Department of Labor OSHA 1910.213 Regulation.
To Next Page
Loading...
