Appendix
A
In the descriptions below, the lines marked with ">" show
what
is displayed
in
the
top row
of
the readout.
EXER
05
Display Operating Time and Power Cycle Count
> HRS
ON
nnnn
OFF/ON CYCLES mmmm
nnnn
= Accumulated Number
of
Hours with Power Applied
mmmm = Accumulated Number
of
Power Cycles
EXER 06 Select Setup
to
Use at Power Up
> POWER UP TO POWER DOWN SETUP
Instrument will power
up
with the setup
in
effect
at
power down.
> POWER UP TO SETUP 1
Instrument will power
up
with the setup stored as setup
1.
EXER 07 Enable/Disable Setup SAVE and Sequence Definition
> ENABLE SAVE AND SEQUENCE-CHANGE
All Save and Sequence functions are enabled.
> DISABLE SAVE AND SEQUENCE-CHANGE
All Save and Sequence-definition functions are disabled.
> ENABLE SAVE 1 -
8,
NO SEQ-CHANGE
Only setups 1 through 8 can be changed. BEGIN/STEP/END
attributes cannot be changed for any setup.
EXER
08 Initialize Setups
A-2
> COUPLING UP CLEARS SAVED SETUPS
Press upper Trigger COUPLING
to
clear all saved setups.
Press
lower Trigger COUPLING
to
retain saved setups.
2465A/2455A/2445A Operators
To Next Page
Loading...
Need help?
General
