Save
and
Recall Operation
You can easily record any instrument setup for unlimited future use. Eight setups
are
directly accessible by using SAVE and RECALL as prefixes
to
the setup number
buttons, 1 through
8,
which are also the Vertical MODE buttons. Twenty-two more
setups are
accessible using the
~
control
to
scroll through the list. You can arrange
setups
In
sequence and recall them in order by pressing STEP/AUTO. Sequences
automatically restart when they are
completed.
Save and Recall Help
Any time you need more information to proceed with a SAVE
or
RECALL
operation, press
SAVE/HELP
or
RECALl/HELP again. Each time you press
SAVE/HELP or RECALl/HELP, the readout shows another message. The
messages appear in a repeating sequence.
Save a Setup (Direct Save setups 1-8)
1.
Set the instrument to make a particular measurement
or
observation.
2.
Press SAVE. The readout will indicate the Direct Save mode.
Top Row
Cursor
Bottom Row --
SAVE 1-8 DIRECTLY.
NAME:xxxxxxx
PUSH ANY OF 1-8 TO SAVE SETUP.
(If the Direct-Save mode displays
·SAVE
FUNCTIONS DISABLED," refer
to
EXER 07, described in Appendix
A)
3. If you want a new name
for
the setup, turn
~
to
define the first
character, then turn
~
REF
to
select and
~
to
define each additional
character, up
to
seven. A small cursor marks the character selected for
definition.
4. Press one of the setup number buttons. The readout will show, in the
corner, the number
of
the button you pushed and either the new name
you defined
or
the name
of
the setup previously associated with that
setup number.
Save a Setup (Extended Save setups 9-30)
2-32
You can also save more than 8 setups by pressing STEP/AUTO, and
turning
~
to
the desired extended setup location. To name the selected setup,
follow step 3 of Save a Setup (Direct Save setups 1-8), pressing STEP/AUTO
when finished. If the name for the setup is
to
remain the same, then just press
STEP/AUTO.
REV JAN 1987 2465N2455N2445A Operators
To Next Page
Loading...
Need help?
General
