Tektronix PS 5010

Operating Instructions-PS 50 1 Q
DISPLAYS AND DESCRIPTIONS
Buttons Pushed
(Power on)
4- All bright
I
SUPPLY
To enter either
parameter in
SELECT different supply.
-[
Operating mode
1 4-, All dim -
NEG POS TRACK LOGIC
To enter the
Lother parameter
-\
in same supply. \
CURRENT VOLTAGE + Default
VOLTS or AMPS lights
flashing or steady. If
steady supply is at
limit, if flashing no.
4
789
4 5 6
123
OaC
quits flashing. Supply
goes to new param-
eter value.
4- Digits selected are
bright. NOT ENTERED
light flashes.
NOT ENTERED light
Entry mode
All displays bright.
t
Operating mode
Fig.
2-3. Sequence of events used to enter a parameter into a supply.