Tektronix T202 User Manual

r
..
OPERATORS SAFETY SUMMARY
The sa fe ty information in th is s ummary is tor oper-
ating pe rs onnel . Warnings and cautions will also
be fo und throughout the manual where they ap-
pl y.
Measurement Specifications
M ax imum saf e operating potential betwe en probe
c ommon plus input circuit to earth ground shall not
ex ceed 42 vo lts de + peak ac.
Measuring terminal input common references are
c onnected to each other internally . To avoid
measureme nt errors , do not connect voltages of
di fferent potentials between input terminals com-
mons .
For floating measurements above 42 volts peak ,
TEKTRONIX model A6902B is recommended for
s afe measurement operat ions.
Terms in this Manual
CAUTION statements identify conditions or prac-
ti ces that could result in damage to the equipment
or other property.
WARNING statements identify conditions or
practices that could result in personal injury or loss
of life.
Terms as Marked on Equipment
CAUTION i ndicates a personal injury hazard not
immediately accessible as one reads the mark-
ings , or a hazard to property , including the equip-
ment itself.
DANGER in dicates a persona l injury ha za rd im-
mediately accessible as one reads the marking .
IV
Symbols in this Manual
This symbol ind ica tes where applicable
cautionary or other information is to
be found . For maximum input voltage
see the T202 Electrical Characteristics
in Section 5.
Symbols as Marked on Equipment
ATTENTION - Refer to Manual.
Po we r Source
Use only the Ac Power Adapter specified for prod-
uct in put voltage rating . For battery operation ,
refer to " Battery Pack " in Section 1.
Do Not Operate in Explosive Atmospheres
Do Not Remove Covers or Panels
Do not remove the product covers or panels. Do
not operate the product without the covers and
panels properly installed.
V

Tektronix T202 Specifications

General

Brand	Tektronix
Model	T202
Category	Test Equipment
Language	English