Tektronix TDS2000C series User Manual

USB Flash Drive and Device Ports
6. If printing fai
ls, check that the USB cable is connected to the PictBridge port
on the printer, and try again.
NOTE. The oscilloscope stores these settings until you change them, even if you
push the Default Setup button, or you power off the oscilloscope.
NOTE. To stop se nding the screen image to the printer, push Abort Printing.
74 TDS2000C and TDS1000C-EDU Series Oscilloscope User Manual

Tektronix TDS2000C series Specifications

General

Brand	Tektronix
Model	TDS2000C series
Category	Test Equipment
Language	English