Telect ELF-9716-1900 - Chapter 2: ELF DS1 Modules; ELF 8-Termination DSX-1, Wire-Wrap I;O (Model ELF-1008-1100); Figure 11 - Model ELF-1008-1100 Dimensions

© Telect, Inc., All Rights Reserved, 124317-10 A0
1.509.926.6000 :: telect.com
17
ELF System
Copper / Fiber :: ELF Family
Chapter 2: ELF DS1 Modules
Telect offers ve DSX-1 and two DNI-1 ELF Modules:
• All three ELF DSX-1 8-Termination Modules feature network element RJ45, BNC, or wirewrap connections on
the rear and Telect’s Bantam patch/monitor jacks and wire-wrap crossconnections on the front.
• Both ELF DSX-1 6-Termination Modules are total front access modules. Wire-wrap network element, wire-wrap
cross-connections, and Bantam patch/monitor jacks are all on the front.
• Both ELF DNI-1 4-Circuit Modules contain RJ48C termination on the front along with 4 sets of Bantam
patch/monitor jacks for the NE interconnections. One DNI-1 module is total front access with all Bantam
interconnections between RJ48C NE-1/NE-2 terminations; the other module interconnects four NE-2 RJ48C
termination on the front with wire-wrapped NE-1 termination on the rear.
2.1 ELF 8-Termination DSX-1, Wire-Wrap I/O (Model ELF-1008-1100)
Eight-circuit network element I/O wire-wrap pineld on the rear and corresponding cross-connect pineld and
Bantam-style patch and monitor jacks on the front. Both pinelds provide individual shield grounds for each set of
jacks. Screws for mounting module to an ELF chassis or lockable wall-mount enclosure are included.
Circuit Designation
Label
Jumper
Tie-Down Bar
Cross-Connect Pins
8-Termination Module
DSX-1 Bantam
Jacks
Network Element Pinfield
0.78 (19.9)
5.50
(139.7)
5.11 (129.7)
1.63
(41.3)
0.55
(13.9)
Note: Dimensions are in in. (mm)
Top View
5.86 (148.8)
Figure 11 - Model ELF-1008-1100 Dimensions