Teletek electronics TTE Combo - 1. INTRODUCTION; 1.1 General Information

TTE Combo Communication Module – Installation and Programming Manual
4
1. INTRODUCTION
1.1 General Information
TTE Combo is a universal communication module, that can be connected to any panel capable to
transmit CID events, including Eclipse Series. The general application of the module is to transmit the
incoming events from the panel (the events recorded into the panel’s memory log file) to AJAX SP
Pro server and/or SIA-DC09 Receiver station via several reporting channels – LAN/GPRS/PSTN
(communication media) – using alternative or parallel reporting type.
TTE Combo is a module for emulation of a standard PSTN line or Receiver Station. The module
receives the events from the connected alarm control panel and returns a confirmation for the
successful receiving. TTE Combo is equipped with an internal loop buffer with capacity of 256 events.
In case of overflow of the internal buffer, the module stops the confirming of successfully received
events. In this way the untransmitted events will be kept into the log buffer of the alarm control
panel and would not be lost. These events will be transmitted when the module’s buffer is unloaded
during the next successful transmitting of events to AJAX SP Pro server or SIA-DC09 Receiver station.
The received CID (Contact ID) events are converted internally into SIA code.
Reporting via “SIA over IP” protocol is realised via standard GPRS and/or LAN channel. The user can
use one or both reporting channels. When the both reporting channels are used, the user can set
their priority of using – setting one for main and the other for a backup – alternative reporting type.
There is also an option for using a parallel reporting type, as the events are transmitted via the both
reporting channels.
When the control panel is additionally equipped with a digital communicator, the standard PSTN
telephone line can also be used for backup channel for transmitting of events, as the TTE Combo is
connected directly to the digital communicator terminals of the panel. The hardware connection with
the panel is monitored and in case of fault or trouble with the line the module will report to the
monitoring station.
In case of connection to Eclipse series control panel, TTE Combo is fully compatible and can operate
in configuration with Eclipse VD (voice dialer) mounted on slot to the panel’s PCB. The user can use
the full functionality of the Voice Management Mode and the monitoring via TTE Combo through the
available PSTN line.
The user also can remotely control the outputs of TTE Combo via AJAX WEB software application and
MobileTTE smartphone application.
According the application, TTE Combo can be powered up directly from the control panel (± AUX
terminals, 9-30VDC) or from a stand-alone power supply unit. The module can be mounted directly
into the panel’s box or into a separate small plastic box (SB-U) suitable for wall mounting according
the application.
TTE Combo is programmed via ProsTE software or remotely via AJAX Web User Interface.