Teletek electronics TTE Combo - 7. APPENDIX - SIA CODES

TTE Combo Communication Module – Installation and Programming Manual
34
7. APPENDIX – SIA CODES
SIA
Code
Event Code Description Address Field
AN Analog Restoral
An analog fire sensor has been restored to normal
operation.
Zone or point
AR
AC Restoral
AC power of the control panel has been restored.
Unused
AS
Analog Service
An analog fire sensor needs to be cleaned or calibrated.
Zone or point
AT
AC Trouble
AC power of the control panel has been failed.
Unused
BA
Burglary Alarm
Burglary zone has been violated while armed.
Zone or point
BB
Burglary Bypass
Burglary zone has been bypassed.
Zone or point
BC
Burglary Cancel
Alarm has been cancelled by authorized user.
User number
BD Swinger Trouble
A non-fire zone has been violated after a Swinger
Shutdown (short intermittent) on the zone.
Zone or point
BE Swinger Trouble Restore
A non-fire zone restores to normal from a Swinger (short
intermittent) Trouble state.
Zone or point
BH
Burglary Alarm Restore
Alarm condition eliminated.
Zone or point
BJ
Burglary Trouble Restore
Trouble condition eliminated.
Zone or point
BM
Burglary Alarm - Cross Point
Burglary alarm w/cross point also in alarm - alarm
verified.
Zone or point
BR
Burglary Restoral
Alarm/trouble condition has been eliminated.
Zone or point
BS
Burglary Supervisory
Unsafe intrusion detection system condition.
Zone or point
BT
Burglary Trouble
Burglary zone disabled by fault.
Zone or point
BU
Burglary Unbypass
Zone bypass has been removed.
Zone or point
BV Burglary Verified
A burglary alarm has occurred and been verified within
programmed conditions (zone or point not sent).
Area number
BX
Burglary Test
Burglary zone activated during testing.
Zone or point
CA
Automatic Closing
System armed automatically.
Area number
CD Closing Delinquent
The system has not been armed for a programmed
amount of time.
Area number
CE
Closing Extend
Extend closing time.
User number
CF
Forced Closing
System armed; some zones not ready.
User number
CG
Close Area
System has been partially armed.
Area number
CI Fail to Close
An area has not been armed at the end of the closing
window.
Area number
CJ
Late Close
An area was armed after the closing window.
User number
CK
Early Close
An area was armed before the closing window.
User number
CL
Closing Report
System armed, normal.
User number
CP
Automatic Closing
System armed automatically.
User number
CQ
Remote Closing
The system was armed from a remote location.
User number
CR Recent Closing
An alarm occurred within five minutes after the system
was closed.
User number
CS
Closing Keyswitch
Account has been armed by keyswitch.
Zone or point
CT
Late to Open
System was not disarmed on time.
Area number
CW Was Force Armed
Header for a force armed session, forced point msg. may
follow.
Area number
CZ Point Closing
A point, as opposed to a whole area or account, has
closed.
Zone or point
DC
Access Closed
Access to all users prohibited.
Door number
DD
Access Denied
Access denied, unknown code.
Door number