TTE Combo Communication Module – Installation and Programming Manual
7
Operation as Stand-Alone Device
This configuration is suitable for realizing of home automation applications where the User wants to
control different electrical appliances via the outputs of the module. In this case, TTE Combo must be
powered up from and external power supply unit providing 9-30VDC. The outputs can be switched
ON/OFF remotely via AJAX WEB or MobileTTE.
1.2 Before you start
Before starting you need the following equipment (full configuration):
- ProsTE Programming Software installed on a local computer or laptop for reading, writing and
saving the module’s configuration.
- Standard USB-Micro USB data cable.
- Valid SIM Card supporting 2G networks with disabled PIN protection code.
- Router.
- CAT-5 Ethernet cable, max. 90 m (not included into the kit).
- Access to WAN/LAN available and enabled network.
- Control panel with digital communicator (supporting CID protocol).
- Access to PSTN available network.
- Resistor 220k (included in the kit of the supplied equipment) for termination of the terminals of the
digital communicator for phone device connection (in case the phone device is not used).
And also, is helpful to have prepared:
- A valid account registration in AJAX WEB User interface*.
- An installed Mobile TTE application on your smartphone**.
* For monitoring and management of burglary control panels Eclipse series and module’s outputs. Ask your
local distributer or security provider how to access the AJAX WEB site and to register an account.
** You can download the application from Google Play or App Store according your smartphone model. You will
be able to review all attached systems to your AJAX WEB account after adding them into the Mobile TTE
application.
The manufacturer also recommends:
- Review the status of the burglary alarm panel to which the TTE Combo module is going to be
connected. Check the programming and settings for operation with communication equipment. Set
the phone numbers: one for communication with the Central Monitoring Station, and other for
connection with TTE Combo module. Set CID protocol for transferring of events.
- Check the subscription plan of the used SIM card and network coverage. The SIM card must support
2G network. To be able to connect to AJAX SP Pro Server and use the Mobile TTE application on your
smartphone, your plan must include a mobile internet (at least 100MB data traffic per month).
- In case the TTE Combo is going to be used as a stand-alone device, equip it with a suitable external
power supply unit providing 9-30VDC.
- Connect the “In1” terminal of the module to the TAMPER switch of the control panel (or to a
TAMPER Zone type).
- Equip your Router device for access to WAN/LAN network with an uninterruptable power supply
(UPS) unit.
When only LAN communication media of TTE Combo module is going to be used for reporting of
events in your burglary alarm system for security, it is obligatory to equip your Router device with
a UPS unit. In this way, in case of a main power supply failure in the protected site, the router will
stay powered on and will be able to send messages for “AC lost” and “Burglary Alarm” to the
monitoring station and/or the end user.
To Next Page
Loading...