Telstra Elite - Page 57

TELSTRA ELITE® GATEWAY USER GUIDE
57
Option Description
IP Address
EntertheIPaddressfortheLANinterface
Subnet Mask
EnterthesubnetmaskfortheLANinterface
Enable Internet Group
Management Protocol (IGMP)
Snooping
EnablebytickingtheboxStandardMode:Instandardmode,
multicasttrafficwillfloodtoallbridgeportswhennoclient
subscribestoamulticastgroup.
BlockingMode:Inblockingmode,themulticastdatatrafficwill
beblocked.Whentherearenoclientsubscriptionstoamulticast
group,itwillnotfloodtothebridgeports.
Enable NAT
Toenable/disableNetworkAddressTranslation(NAT,pleaserefer
to7.2forNATsetting).BydefaultNATisenabled.
Enable UPnP
TicktheboxtoenableUniversalPlugandPlay
Dynamic Host Configuration
Protocol (DHCP) Server
SelectenableDHCPserverandenteryourstartingandendingIP
addressesandtheleasetime.Thissettingconfiguresthegateway
toautomaticallyassignIP,defaultgatewayandDNSserver
addressestoeveryDHCPclientonyourLAN
Static IP Lease List
TospecifytheIPaddressassignedthroughDHCPaccordingtothe
MACaddressofthehostsconnectedtothegateway.
Enable DHCP Server Relay
TorelayDHCPrequestsfromthesubnetwithnoDHCPserveronit
toaDHCPserveronothersubnets.DHCPServerRelayisdisabled
bydefault.ToaccessenableDHCPrelay,pleaseun-tickNATenable
first,thatmeanstodisableNATfirst,andthenpresssavebutton.
TheenableDHCPserverRelayoptionwillthenshowuponthe
samepageasbelow:
ConfigureasecondIPaddressbytickingthecheckboxshownbelowandenterthefollowing
information:
IP Address:
EnterthesecondaryIPaddressfortheLANinterface.
Subnet Mask:
EnterthesecondarysubnetmaskfortheLANinterface.
NOTE: The Save button saves new settings to allow continued configuration, while the Save/Reboot button not only saves
new settings but also reboots the device to apply the new configuration (i.e. all new settings).