Telstra Elite - Default Settings

To Next Page

To Previous Page

TELSTRA ELITE® GATEWAY USER GUIDE

3.3 DEFAULTSET TING S

Thefollowingarethedefaultsettingsforthegateway:

• Local(LAN)access(username:admin,password:admin)

• Remote(WAN)access(username:support,password:support)

• Useraccess(username:user,password:user)

• LANIPaddress:10.0.0.138

• RemoteWANaccess:disabled

• NATandfirewall:enabled

• DynamicHostConfigurationProtocol(DHCP)serveronLANinterface:enabled

Technical Note:

During power on, the device initializes all settings to default values. It will then read the configuration profile from the permanent

storage section of flash memory. The default attributes are overwritten when identical attributes with different values are

configured. The configuration profile in permanent storage can be created via the web user interface, telnet user interface, or

other management protocols. The factory default configuration can be restored either by pushing the reset button for more than

five seconds until the power LED blinks or by clicking the Restore Default Configuration option in the Restore Default Settings

screen (see section 7.1.3).

Other manuals for Telstra Elite