Telstra Elite - Signal Selection

TELSTRA ELITE® GATEWAY USER GUIDE
29
5.2 S I GNALSELECTION
SignalSelectionallowsyoutomanuallyselectthe3Gsignalinputtobeeithertheinternal
antennasoranexternalantenna(notincluded).Bydefault,astablesignalisobtainedfrom
theantennasbuiltintothegateway.Touseanexternal3Gantenna,pleaseconnectittothe
AntennaConnectornexttothePowerInputonthebackofthegateway.
Iftheexternalantennadoesnotsupport850MHzfrequency,pleasegotoNextGSettings>
SettingsandselectAllBands/Automaticbeforeselectingsignalinput.
Thegatewaycandetectandautomaticallyselectthehighersignalstrengthbetweeneither
theinternalantennasorfromtheexternalinput.Toinitiatetheautoselectprocess,please
selectAutoSelectandclickonSave/Apply.TheAutoSelectprocesstakesabout170seconds.
ClosethewebbrowseronyourcomputeranddonotusetheInternetduringthewhole
process.
Theresultsoftheselectionwillbeshownonscreen.Iftheinternalandexternalsignalsare
onthesamelevel,thegatewaywillselecttheInternalAntennasasinput.
Thegatewayisabletorememberthelastselectedsignalinputbeforepower-off.Ifthesignal
inputischangedtotheExternalAntennaitwillobtainasignalfromtheexternalantenna
afterrestart.