OPERATION
Tennant T5 (12- 13)
11
MACHINE SETUP
ATTACHING SQUEEGEE ASSEMBLY
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, set parking brake if
equipped, turn off machine and remove key.
1. Park the machine on a level surface, remove the
key and set the parking brake if equipped.
2. Lift the squeegee lift lever to the upward position
(Figure 4).
FIG. 4
3. Mount the squeegee assembly to the squeegee
pivot bracket and secure with knobs (Figure 5).
FIG. 5
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the hose
clip provided (Figure 6).
FIG. 6
5. Check the squeegee blades for proper deflection.
The blades should deflect as shown (Figure 7).
FIG. 7
6. To adjust the blade deflection, place the squeegee
assembly on a level surface and adjust the casters
as shown (Figure 8).
2mm
Lock Nut
FIG. 8
INST ALLING BRUSHES/PADS
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, set parking brake if
equipped, turn off machine and remove key.
Disk Model:
1. Raise scrub head off the floor and remove key.
2. Attach the pad to the pad driver before installing
the driver. Secure pad with centerlock (Figure 9).
FIG. 9
To Next Page
Loading...
