Tennant T5 - Ec-H2 O Nanoclean Water Conditioning Cartridge (Ec-H2 O Nanoclean Model); Installing Fast- Pak Carton (Fast Model); Cartridge (Ec-H2 O Nanoclean Model)

OPERATION
Tennant T5 (06- 15)
13
ec-H2O NanoClean WATER CONDITIONING
CARTRIDGE (ec-H2O NanoClean model)
(ec-H2O models labeled ec-H2O NanoClean)
The ec-H2O system is equipped with a water
conditioning cartridge. The cartridge is designed to
protect the machine’s plumbing system from potential
scaling. The cartridge is located behind the right side
brush motor (Figure 15).
The cartridge is required to be replaced when it reaches
its maximum water usage or expiration time of when the
cartridge was activated, which ever comes first.
Depending on machine usage a new cartridge can last
up to 24 months.
FIG. 15
All cartridges are labeled with a manufacture date. The
shelf-life of an un-installed cartridge is one year from
manufacture date. For new cartridge replacement, the
ecH2O module timer must be reset. See ec-H2O
NanoClean WATER CONDITIONING CARTRIDGE
REPLACEMENT.
ATTENTION: During first time use and after replacing
the water conditioning cartridge, the ec-H2O system
will automatically override the selected solution flow
rateforupto75minutes.
The ec-H2O system indicator light will blink green/red
when it’s time to replace cartridge (Figure 16).
FIG. 16
INST ALLING FaST- PAK CARTON (FaST Model)
ATTENTION: The FaST- PAK Concentrate Formula
is specifically designed for the FaST system.
NEVER use a substitute. Machine damage may
result.
1. Pull out the hose connector from the FaST- PAK
carton and remove cap (Figure 17).
FIG. 17
2. Open the battery compartment. Connect the
FaST- PAK carton to the supply hose and place
carton in compartment (Figure 18). Make sure the
hose does not get pinched.
FIG. 18
3. When the supply hose is not in use, connect the
storage plug to prevent the FaST system from
drying out and clogging up the hose. (Figure 19).
FIG. 19