EasyManuals Logo

Terex RT500-1 User Manual

Terex RT500-1
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #192 background imageLoading...
Page #192 background image
Slider Pads
The front bottom slider pad should be checked daily for wear. The remainder of the slider
pads should be checked monthly for wear.
All the slider pads contain a chamfer (1) on the wearing surface. When this chamfer is worn
off, the slider pad must be replaced.
With boom extended brush grease on areas of boom where wear pads contact is evident.
he inside of the top plate of all sections except the tip section also require grease. This can
be applied through the holes in the side plates and “piled” on top of the next section out
just in front of the top rear pads on that section so that extending the boom to the next hole
smears the grease onto the inside of the top plate. Remember to do both sides.
Grease intervals vary and should be more frequent if noise or jerking of the boom is evident.
189
REVISED:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Terex RT500-1 and is the answer not in the manual?

Terex RT500-1 Specifications

General IconGeneral
BrandTerex
ModelRT500-1
CategoryConstruction Equipment
LanguageEnglish

Related product manuals