Steering Priority Valve Adjustment
The steering priority valve is preset at the factory and will normally not require any
additional adjustment. In the event that a new valve is installed or steering performance is
poor and all other components and adjustments have been verified, adjustment of the valve
may be required.
The steering priority valve is located inside the super structure just to the right of the rotary
manifold.
STEERING PRIORITY VALVE ADJUSTMENT
Adjust this valve using the following procedure:
1. Remove the hydraulic hose connected to fitting “1”.
2. Remove fitting “1”.
3. Turn adjustment “3” clockwise until it bottoms out.
4. Turn adjustment “3” counterclockwise 2 full turns.
5. Reinstall Fitting “1” and the hydraulic hose.
253REVISED:
To Next Page
Loading...
Need help?
General
