portions of each cylinder rod is required. Solvent applied with plastic or copper
wool can be used, but abrasives such as sandpaper should never be used to
clean the exposed surfaces of the cylinder rod. If surface damage to the
chrome plate is discovered, the frequency of corrosion barrier applications
should be increased.
NOTE: Caution must be used when cleaning equipment in service with high
pressure washes. Soaps or chemicals containing chlorines or other corrosive
elements should be avoided. Cylinders should be cleaned in a retracted position as
not to expose rods to the chemicals. Cylinders should be cycled immediately
following the wash. If rods are to be stored in the extended position, refer to steps
1-4 above.
RT500
Maintenance
200 REVISED:
To Next Page
Loading...
