Model TA50RT
Rev. 1 04/99
5
5 - 5
MAINTENANCE SCHEDULES
5.2.2. WEEKLY
In addition to the daily checks, the following checks should be carried out by an experienced technician :-
(a) Check control valves for self-centre.
(b) Inspect hydraulic system for leakage.
(c) Check steering system for oil leakage and wear.
(d) Check battery electrolyte levels.
(e) Check pivot pin security.
(f) Grease zoom pads.
(g) Lubricate slew ring gear teeth.
(h) Check rotation box securing bolts for tightness.
(i) Grease cylinder pivot pins, steering pivot pins and slew ring (Figure 5.2)(see also Section 5.4).
(j) Check axle oil level.
(k) Ensure all labels are legible and in place.
(l) Check all hoses and cables through slew ring for wear.
(m) Check the battery and mountings as follows:
(i) Check the start battery and mounting frame for signs of damage.
(ii) Check battery terminals for corrosion. Clean and apply Vaseline to terminals.
(iii) Check the battery electrolyte level and, if necessary, top-up with distilled or de-mineralised
water.
(n) Check the manifold assembly. Operate the motor and carry out the following checks:-
(i) Check the security of blocks and solenoids.
(ii) Check the security and condition of hoses and cables.
(o) Check the hydraulic oil tank as follows:-
(i) Check the tank for security
(ii) Check the tank for leakage.
(iii) Check that the handpump is operational by screwing in one of the function knobs and pumping
the handle. (Remember to unscrew know afterwards.)
(p) Check the minor equipment as follows:-
(i) Check all minor equipment for security
(ii) Check for oil leakage
(iii) Check all cables for security and damage.
To Next Page
Loading...
