Description
TV800/900 Roller 0102-5 April 2011 5-10
Drive Control Lever
Vibration Button
Pressing the button once will start the vibration system, pressing
the button a second time to stop vibration.
The vibration button will only operate when the lever is out of
the neutral gate and within the half speed range. Should the
control lever be moved to the full speed position or allowed to
enter the neutral gate vibration will stop automatically.
Hand Throttle
The hand throttle (A) is positioned to the right of the drivers
seat.
The hand throttle has 3 set positions:-
1 - Idle
2 - Low Frequency Vibration
3 - High Frequency Vibration
When the throttle lever is moved from Idle - position (1) and
passes through position (2) the lever is automatically locked in
position 2 by a spring loaded pin.
To continue moving the lever the release collar (B) must be
lifted to release the pin and allow the lever to be moved. If the
lever is moved to position (3) the lever will again be locked in
position by the spring loaded pin and the release collar (B) must
again be lifted to move the lever from this position.
NOTICE
Do Not Select Vibration On Hard Surfaces.
To Next Page
