9-11 TV800/900 Roller 0102-5 April 2011
Maintenance
Hydraulic Tank
Removal
• Thoroughly clean the machine, especially the area around
the hydraulic tank.
• Operate the machine so the hydraulic oil is warm -Not Hot.
• Lift and support the machine at a suitable height to enable
the hydraulic tank to be lowered and removed from the
machine.
• Remove the drain plug (D) and allow oil to drain into a
suitable container then temporarily replace drain plug.
• Remove the three hoses from the top of the tank Plug hose
ends to prevent contamination.
• Support the hydraulic tank (A) and remove the 6 bolts
holding the tank support frame (B) to the front chassis frame
(C).
• Lower the tank and slide it from underneath the machine.
• Plug the hose unions in the top of the tank and thoroughly
clean outside of tank.
• Remove suction strainer plate (E) and drain plug (D).
• Remove all traces of gasket from the suction strainer plate
and tank face.
• Thoroughly wash inside of tank with a suitable solvent and
allow to dry.
• Clean and refit drain plug using a new sealing washer.
• Replace both suction strainers on strainer mounting plate.
• Refit strainer mounting plate using a new gasket.
Replacement
• Reverse the removal procedure to replace the tank.
• Fill tank with correct grade of oil - see Page 9-18.
b
It will be necessary to lift the machine to enable the tank to
be removed from underneath the machine.
The machine must be suitably supported, once lifted, on
suitable stands of sufficient strength to take the weight of
the machine.
DO NOT WORK UNDER AN UNSUPPORTED MACHINE
To Next Page
