Terex TV800 - Water Sprinkler System; Tank - Removal; Filter; Tank - Refitting

9-13 TV800/900 Roller 0102-5 April 2011
Maintenance
Water Sprinkler System
Tank - Removal
• Remove the rear chassis back plate (A) to expose the water
tank (B). If lights are fitted disconnect the lighting wires at
the connector.
• Drain the tank by turning on the water valve and
disconnecting the quick-release coupling (C) (slide collar
back and pull apart) at the bottom of the tank.
• Remove the water tank by pulling it rearwards.
Filter
• Unscrew the cap (D) at the base of the tank and remove it
complete with the water outlet connection and filter.
• Wash the filter with clean running water, If the filter is
damaged or severely blocked, replace it.
• Wash the tank out thoroughly with clean water.
• Refit the filter assembly and cap (D).
Tank - Refitting
• Refit the water tank into the rear chassis.
• Reconnect the quick release coupling.
• If lights are fitted reconnect the wires at the connector. Refit
the rear panel.
0102-9-019
A
B
0102-9-020
C
D