Maintenance
TV800/900 Roller 0102-5 April 2011 9-12
Water Sprinkler System
Water Tank - Filling
The filler cap is located under the operators right hand armrest.
• Position machine on level ground.
• Unlock the arm rest lock (A) using an 8mm square key and
lift the arm rest (B) clear.
• Unscrew the filler cap (C) and add clean fresh water until the
level is approximately 50mm (2ins) from the bottom of the
filler neck.
• Re-fit filler cap (C) and tighten.
• Close arm rest and lock.
Draining
Drain the tank by opening the sprinkler valve or by
disconnecting the quick release coupling on the base of the
water tank
Testing Water Flow
Open the valve and check that water flows through every hole
in each spray bar.
If water does not flow check the filter and spray bars for
obstructions.
The spray bar end plugs can be removed to assist cleaning.
NOTICE
In Sub-Zero Temperatures Drain The Tank If The Machine
Is Not In Use
To Next Page
