Terex TV800 - Hydraulic Tank

9-9 TV800/900 Roller 0102-5 April 2011
Maintenance
Hydraulic Filter
The hydraulic filter (A) is fitted with a blockage indicator (B)
which “pops up” to indicate when the filter is blocked and the
element requires changing.
To change the element
• Remove the 4 socket head cap screws (C) securing the top of
the filter and lift the top clear.
• Lift out the element and discard.
• Fit new element ensuring it is aligned correctly.
• Replace the cap, fitting a new O ring seal if necessary. A peg
in the cap ensures correct alignment.
• Refit and tighten cap screws.
Hydraulic Tank
Draining
Before draining the hydraulic oil tank the machine should be
run to enable the oil temperature to increase which will allow
the oil to drain more easily. The oil should be warm - NOT
HOT.
• Clean the area around the drain plug.
• Loosen the drain plug (B).
• Position a suitable under the tank to catch the oil.
• Remove the drain plug and allow oil to drain completely.
• Clean drain plug and fit a new sealing washer (C).
• Refit the plug and fully tighten.
Refilling
When filling the hydraulic tank use new oil of the correct grade
and ensue all containers are clean.
0102-9-007
A
B
C
b
The Machine MUST be on Firm, Level Ground
0102-9-008
A
C
B