9-5 TV800/900 Roller 0102-5 April 2011
Maintenance
Engine Coolant
The cooling system is pressurised to increase the boiling point
of the coolant, therefore extreme caution should be taken when
carrying out maintenance on the cooling system to prevent
scalding.
Topping Up Cooling System
This operation should only be performed when the engine is
cold. The engine coolant header tank (A) is located above the
engine forward of the air cleaner.
Coolant is added through the filler cap (B). The correct level
when the engine is cold is just below the seam of the tank (C).
Coolant
When adding coolant ensure it is a mixture of water and
antifreeze to the correct ratio for the temperature range that the
machine is to be used in. See 10-Specifications section for
correct mixture ratios.
b
DO NOT Remove The Filler Cap When The Engine Is HOT.
b
NEVER start engine without coolant in the cooling system
Never remove header tank cap with engine running
ANTIFREEZE is TOXIC. If accidentally swallowed, medical
advice must be sought immediately.
Antifreeze is corrosive to the skin, If accidentally spilled
on the skin it must be washed off immediately.
Protective clothing and eye protection should be worn
when handling antifreeze.
To Next Page
