Terrasat IBUC - Page 71

Table 6-9 IBUC M&C Command Set
Parameter <value> Valid Values
(See Notes Below)
Comments Command Burst/
CSM
Mode
Config
allowed
if slave?
Default Value
HHT
[Note
4]
RS-
232
Port
RS-
485
Port
ASCII
FSK
Port
ASCII
RS-485
Binary(1)
FSK Port
Binary(1)
Telnet
Port
IBUC Operation Manual 6-22
Terrasat Communications, Inc.
Rev. A
SWITCH=A or B or
Faulted
Get Switch
Position
0=A, 1=Bee Returns current
redundancy switch
position. I.E. If the
switch is in position
A, then this
command will return
0.
BSW? all na X X X X No No X
Set Switch
Position
0=A, 1=B Sets the switch to
position indicated.
Requires
Redundancy mode
to be in Manual
Mode.
BSW=<value> all na X X X X No No X
Transmit
Get Output
Transmit
Alarm High
Threshold
Returns Output high
power level
threshold
TAH? all na X X X X No No X
Set Output
Transmit
Alarm High
Threshold
0.0-60.0
(corresponding to
0.0 to 60.0 dBm in
0.1 dB steps).
Further qualified by
ODU output range of
P1dB to P1dB-20dB.
Must be above Low
Threshold.
Sets Output high
power Level
threshold. A level
alarm is set if the
threshold is
exceeded.
TAH=<value> all no P1dB + 1 X+- X X X No No X
Get Output
Transmit
Alarm Low
Threshold
Returns Output low
power level
threshold
TAL? all na X X X X No No X
Set Output
Transmit
Alarm Low
Threshold
0.0-60.0
(corresponding to
0.0 to 60.0 dBm in
0.1 dB steps).
Further qualified by
ODU output range of
P1dB to P1dB-20dB
(Must be below High
Threshold)
Sets Output low
power Level
threshold. (same as
TAH except low
threshold)
TAL=<value> all no P1dB - 20 X+- X X X No No X
Get Transmit
Alarm
Simulation
TAS? all na X X X X No No X