ALARM LIST DESCRIPTION
ALARM LIST DESCRIPTION Data: 25.06.2018 Pagina: 2 di 8
ID520263 Speed synchronism mode can not be activated
ID520288 S1 - Eeprom Error
ID520289 S1 - Internal Temperature
ID520290 S1 - Battery Value
ID520291 S1 - Monitor - Can Comunication Fault
ID520292 S1 - Engine Motor - Can Comunication Fault
ID520293 S1 - Engine Motor - Battery Not In Charge
ID520294 S1 - Card S2 - Can Comunication Fault
ID520295 S1 - Card S3 - Can Comunication Fault
ID520296 S1 - Card S4 - Can Comunication Fault
ID520297 S1 - Card S5 - Can Comunication Fault
ID520298 BW1 Speed Joystick Fault
ID520299 BW1 Pull Set Potentiometer Fault
ID520300 RW1 Pull Set Potentiometer Fault
ID520301 BW1 Boost Pump Pressure - TooLow
ID520302 BW1 Boost Pump Oil Filter Obstructed
ID520303 BW1 Speed Joystick Initial Position Not Correct
ID520304 BW1 Pull Max
ID520305 BW1 Stringing Mode - One Output Pin Card Fault
ID520306 BW1 Stringing Mode - Initial Rpm Value Incorrect
ID520307 BW1 Stringing Mode - Pull Valve Set Error
ID520308 BW1 Stringing Mode - Auxiliary Pull Value Not Correct
ID520309 BW1 Stringing Mode - Minimum Pressute To Unlock Brake Incorrect
ID520310 BW1 Stringing Mode - Connected Bull Wheel Not Ready
ID520311 BW1 Stringing Mode - Rotation Valve Regulation Fault To Unlock Brake
ID520312 BW1 Stringing Mode - One Proportional Valve Not Zero Value
ID520313 BW1 Auxliary Valve Already Used to Other Functions
ID520314 BW1 Rope Locker Close
ID520315 BW1 StringingMode - Rpm Not Reached For Tensioner
ID520316 BW1 Gear Box Switch Inconsistent
ID520317 BW1 Lock/Unlock Negative Brake Switch Not In Correct Position
ID520318 BW1 Auxiliary Pull Value Low
ID520319 BW1 Pull Pressure Too High For Release
ID520321 BW1 Release Function Not Permitted
ID520322 BW1 Low Tensioner Active: Function Not Permitted
ID520323 BW1 Negative Brake Closure Requested
ID520325 BW1 StringingMode - Switch Low Tensioner Not Correct
ID520326 BW1 Rotation Not Concorde With That Of BW Reference
ID520327 BW1 Low Tensioner Set Different From Other Bull Wheel
ID520328 BW1 ReelWinder Encoder Error
ID520329 BW1 Fast Speed Selection Already In Use
ID520330 BW1 Release Function Not Permitted
ID520331 BW1 Electrical Coupling Setting Non Available
ID520332 BW1 Recovery/Release Selector On Radio Not In Correct Position
ID520333 BW1 Rope Locker Selector Not Enable
ID520334 BW1 Connection Error - Non-Concording Rotation Sensor
ID520335 BW1 Stringing Mode - Secondary Stand ReelWinder Pull Value Not Correct
To Next Page
Loading...
