Single Station Vicat Test Apparatus
1.0360
15
3.4 Setting the parameters for water temperature control
Figure 8: parameters for water temperature control
Parameters for the temperature control of the water bath:
set point heating
hysteresis heating
set point cooling
hysteresis cooling
correction factor for the temperature sensor of the temperature control
Pressing one of the buttons (Figure 8) will take you to the page where you can edit the parameter.
3.4.1 Setting the set point for the heating
Figure 9: setting set point heating
One-time short press of the button increases the setpoint by 0.1 °C.
Pressing and hold down this button increases the set point continuously by 0.1 °C.
If you press and hold the button for more than 3 seconds, the step size increases to 1 ° C.
This process continues until you either release the button or you reach the maximum permissible value.
One-time short press of the button decreases the setpoint by 0.1 °C.
Pressing and hold down this button decreases the set point continuously by 0.1 °C.
If you press and hold the button for more than 3 seconds, the step size increases to 1 ° C.
This process continues until you either release the button or you reach the minimum permissible value.
To get the set value also after switching off the device press the button.
To Next Page
Loading...
