Single Station Vicat Test Apparatus
1.0360
8
1.7 Connection to the power supply
In accordance with the pertinent standards, connect the socket to the earthing-sys-
tem.
Check the device rating plate to make sure that the ratings of the building power
supply conform to the requirements for voltage, wattage, amperage, and frequency
of the equipment.
The technical characteristics of this safety device must also satisfy the standards that
apply in the country in which the device is installed.
The manufacturer of the equipment is not be liable for any damages that result be-
cause of the information here is not observed.
Electrical tolerances:
Actual voltage: 10% of the rated voltage
Frequency: 1% of the rated frequency, continually; 2% of the rated frequency, on a short-term
basis
The manufacturer shall not be liable for damages to persons or properties that arise because the
above instructions have not been observed.
To protect the electronic components from short circuit, a troughs fuse (250VAC/ 3.6A) are build-in, easily
accessible to the user.
Figure 1: Connections
To Next Page
Loading...